Blog

Two rings: Loop 410 and Loop 1604

San Antonio's inner and outer beltways compared: length, names, history, what each passes and why growth moved the traffic from one ring to the other.

Two beltways circle San Antonio, one inside the other, and every local gives directions in their terms. Loop 410 is the inner ring: dense, urban along its northern arc, close to the airport and the medical center. Loop 1604 is the outer ring, roughly twice as long, urban on the north and rural on the south. A newcomer learns fast that "inside 410," "between the loops" and "outside 1604" are three different San Antonios.

The two roads also tell the city's growth in sequence. The inner loop was built in the 1950s and 1960s as the answer to the traffic of its day, and the outer loop, designated in 1977, has been taking the same pressure ever since. Set side by side, they explain why the largest highway project in the region today is on the outer loop.

The rings in numbers

Published lengths differ, and the differences are worth stating instead of hiding.

Loop 410 Loop 1604
Length, fact sheet figure about 53 miles about 96 miles
Length, a reference page 49.5 miles 94.4 miles (the same page's text says about 95.6)
Official name Connally Loop Charles W. Anderson Loop
Designated Loop 410 on October 15, 1960 June 30, 1977
Part of an Interstate Yes; Interstate 410 since July 31, 1969 No; a state loop
County Entirely Bexar Bexar

Both counts are quoted because the exact mileage is unsettled. Whatever the figure, the outer ring runs about twice as long as the inner.

What twice as long means

A back-of-the-envelope calculation shows why the outer loop matters. If each were a circle, the area enclosed would scale with the square of the circumference. Take 50 miles for the inner loop and 95 for the outer: the ratio is 1.9, and its square is about 3.6. The outer loop would enclose roughly 3.6 times the land. San Antonio's loops are not circles, so this is an illustration and not a measurement. But it explains the pattern: most of the land inside Loop 1604 is not inside Loop 410, and that outer land is where much of the city's newer development has gone.

Who they are named for

Both loops carry names most drivers never use. The inner loop is the Connally Loop, named for John Connally, a former Texas governor. The outer is the Charles W. Anderson Loop, honoring a Bexar County judge who died in 1964 after 25 years in office.

How the inner loop got built

The inner loop's history is a freeway story. According to reference histories, a non-freeway Loop 13 served the city until the 1950s, and its northern half followed the path of today's Loop 410. Construction began in the mid-1950s on the northwest portion near I-10. On October 15, 1960 the section from I-10 to I-35 was redesignated Loop 410. By 1961 the freeway ran from I-35 on the southwest to just east of US 281 near the airport, by 1964 the southern arc reached Roosevelt Avenue and by 1967 the eastern arc met Interstate standards. The section between US 281 and I-35 kept the Loop 410 label until July 31, 1969, when it became I-410.

The widening has never stopped. Reference histories list six lanes from Ingram Road to I-35 north in the late 1970s and early 1980s, then a long reconstruction of the northern arc from the late 1990s to the early 2010s that gave it five lanes each way in places and rebuilt interchanges at I-10 and San Pedro Avenue. The US 281 interchange, nicknamed the "San Antonio Web," fully opened on June 9, 2008. A planned five-level replacement of the I-10 interchange has no date.

What the inner loop passes

According to a reference description, Loop 410 begins and ends at I-35 on the southwest side and crosses I-10 and I-35 twice each, I-37 once and US 90, US 281 and SH 151. It serves several of the region's anchors: San Antonio International Airport, Lackland Air Force Base, Fort Sam Houston, the South Texas Medical Center, Southwest Research Institute and the Toyota Motor Manufacturing Texas plant.

Those anchors connect to topics covered elsewhere on this site: the airport, about eight miles north of downtown, the military installations that make up Joint Base San Antonio and the medical center area. The northern arc serves dense urban neighborhoods, while the southern arc is a four-lane route through mostly undeveloped land that, in the reference's words, feels more rural.

What the outer loop passes

Loop 1604 began as a rural road that became a beltway. It was designated on June 30, 1977, after FM 1604 was combined with a large portion of FM 1518, and its alignment was adjusted several times in the following years around Losoya, Elmendorf and Lone Oak. The US 281 interchange was completed in December 2012.

The outer loop begins and ends at I-10 east of San Antonio and crosses I-10 and US 87 on the north side, I-37 near Losoya, US 281 on the southwest and north sides, SH 16 (Bandera Road), I-35 at both Von Ormy and Universal City, US 90 on the west and north, and SH 151 at its western end. Communities along the route include St. Hedwig, Adkins, Lone Oak, Elmendorf, Losoya, Somerset, Von Ormy, Macdona, Hollywood Park, Shavano Park, Universal City, Live Oak and Converse. Landmarks include UTSA, the Shops at La Cantera, Six Flags Fiesta Texas, the Toyota plant and Camp Bullis.

The north-south contrast is as sharp as on the inner loop. The northern half of 1604 is the most urbanized stretch, running from US 90 near western San Antonio around to the northeast, and the southern half is mostly rural. Master-planned communities such as Stone Oak in the Far North and Alamo Ranch and the Far West Side on the Far West Side are the kind of growth the outer ring serves.

The roads that tie the rings together

The same radial highways cross both loops, which is how a driver moves from one ring to the other. Counting from the reference descriptions:

Radial route Crossed by Loop 410 Crossed by Loop 1604
I-10 twice at I-10 and US 87 on the north side, and where the loop begins and ends in the east
I-35 twice at Von Ormy and Universal City
I-37 once near Losoya
US 90 yes on the west and north
US 281 yes on the southwest and north sides
SH 151 yes at the loop's western end
SH 16 (Bandera Road) not listed yes

Two things follow. First, each ring crosses I-35 at more than one place, so the interstate links the loops at several points. Second, US 281 meets both loops on the north side, and its interchanges with each, the San Antonio Web on Loop 410 in 2008 and the Loop 1604 interchange in 2012, were both finished within the last twenty years.

Reading the exit numbers

Loop 410's exit numbers are mileage from the south I-35 junction, so a higher number means farther around the loop. The reference list has about 60 entries, with lettered variants such as 3A and 13B, and some numbers reused or skipped, so the count is approximate. A driver can work out the distance from the south junction from the exit number alone.

A short timeline

Year Inner ring Outer ring
1950s Loop 13 serves the city; freeway construction begins on the northwest
1960 Redesignated Loop 410 on October 15
1961 to 1967 Freeway extends around the south and east
1969 Becomes Interstate 410 on July 31
1977 Designated Loop 1604 on June 30
2008 The US 281 interchange fully opens June 9
2012 The US 281 interchange completes in December
2021 to 2026 North expansion segments begin; eight I-10 ramps open by February 5, 2026

Why growth moved outward

The shift from the inner loop to the outer follows population. The city's 2020 Census population was 1,434,625, and the Census Bureau's July 2025 estimate is 1,548,422, with a gain of 14,359 in the last year. That growth has to land somewhere, and the outer ring is where a large share of it has gone. Stone Oak and the far north: how master-planned San Antonio grew along Loop 1604 covers the northern side of that story.

You can see the consequence in the work underway. TxDOT is rebuilding Loop 1604 on the north from Bandera Road to I-35, a 23-mile project at $1.4 billion, converting the four-lane expressway to ten lanes and replacing the I-10 cloverleaf with a five-level interchange. Reference histories say Segment 1 began on July 26, 2021, Segment 2 in July 2022 and Segment 4 in April 2024, and that all eight flyover ramps at I-10 opened by February 5, 2026, with segment completion dates between 2026 and 2029. The Loop 1604 North Expansion, segment by segment lists the segments. The inner loop, by contrast, has an I-10 interchange replacement planned but undated.

Using the two rings

For a driver, the rings are a way to plan.

  • Inside 410: the older, denser part of the city, with the airport, the medical center and the military installations the loop serves.
  • Between the loops: the area where the two rings' shared radial routes, I-10, I-35, US 281 and US 90, link them.
  • Outside 1604: the city's edge, where the southern half of the loop is mostly rural and the northern half meets the Hill Country towns.

Before any drive, check DriveTexas, the state's live traffic and construction site, and see How to check DriveTexas before a San Antonio drive for how to read it. TxDOT's San Antonio District, at 210-615-1110, handles questions about both loops, since they are state highways. The city's 3-1-1 line handles city streets, and How to use 311 in San Antonio explains the difference.

Related neighborhoods

Related guides

Latest on this topic